Search found 3 matches
- Wed Jun 17, 2020 12:57 am
- Forum: Support for Ngene Desktop (v1.x)
- Topic: cannot replicate code in manual
- Replies: 4
- Views: 11001
Re: cannot replicate code in manual
Most helpful. Thanks Michiel.
- Tue Jun 16, 2020 2:02 pm
- Forum: Support for Ngene Desktop (v1.x)
- Topic: cannot replicate code in manual
- Replies: 4
- Views: 11001
Re: cannot replicate code in manual
Thank you Michiel. I noticed the manual saying it but didn't realize that I needed to stop for this simple design. Stata and SAS (not used yet but heard) would stop automatically so I imagined I only need to hard stop for more complex designs. Thanks for your answer. I still like Ngene the most so ...
- Tue Jun 16, 2020 12:04 pm
- Forum: Support for Ngene Desktop (v1.x)
- Topic: cannot replicate code in manual
- Replies: 4
- Views: 11001
cannot replicate code in manual
Hi,
I have the most recent version of Ngene, and all permanent setting is on default. I was trying to replicate the code on manual pp99 and 100, attached below. Ngene would continue to run forever and won't give me the result shown on the manual. These commands should take no time to run. Any ...
I have the most recent version of Ngene, and all permanent setting is on default. I was trying to replicate the code on manual pp99 and 100, attached below. Ngene would continue to run forever and won't give me the result shown on the manual. These commands should take no time to run. Any ...